Science · 63 calculators
Period Of A Wave Calculator
The period of a wave is the time it takes for one complete cycle to pass a given point. It is the reciprocal of frequency, so a higher frequency always means a shorter period. Knowing the frequency and the wave speed also gives the wavelength, and multiplying frequency by a time interval gives the number of cycles that occur in it.
Last updated
Period
0.02
- Wavelength
- 6.8
- Period at double the frequency
- 0.01
- Cycles in ten seconds
- 500
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
T = 1 / f
- T
- Period, the time for one cycle, in seconds
- f
- Frequency, cycles per second, in hertz
- lambda
- Wavelength, the length of one cycle, in metres
- v
- Wave speed, in metres per second
- N
- Number of cycles in a given time interval
How to check the result by hand
- 1
Identify the frequency in hertz
Write down the number of cycles per second. If a frequency is quoted in kilohertz, multiply by one thousand; if a rotation rate is given in revolutions per minute, divide by sixty. The period formula needs hertz, so settle the units before doing anything else.
- 2
Take the reciprocal to get the period
Divide one by the frequency. With the default frequency of fifty hertz this gives one over fifty, or zero point zero two seconds. Because the operation is a reciprocal, a large frequency must always produce a small period; if your answer goes the other way, you have multiplied instead of divided.
- 3
Find the wave speed in the medium
Use the speed appropriate to the medium carrying the wave. Sound in air at room temperature travels at roughly three hundred and forty metres per second, while waves on a string depend on the tension and the mass per unit length. The speed is a property of the medium, not of the source.
- 4
Divide the speed by the frequency for wavelength
Compute the wavelength as the wave speed divided by the frequency. For the default case, three hundred and forty divided by fifty gives six point eight metres. Since the speed stays fixed, doubling the frequency halves the wavelength even though the period changes independently.
- 5
Compute the comparison and the cycle count
For the doubled frequency, take one over one hundred to get zero point zero one seconds. For the number of cycles in ten seconds, multiply fifty by ten to get five hundred. These two results show both sides of the reciprocal relationship in one calculation.
Common Questions
How does the Period Of A Wave Calculator work?
The period is one divided by the frequency. A wave at 50 hertz has a period of 0.02 seconds. At a speed of 340 metres per second its wavelength is 6.8 metres, doubling the frequency halves the period to 0.01 seconds, and 500 complete cycles pass in ten seconds.
What do I need to enter in the Period Of A Wave Calculator?
It takes 2 inputs: Frequency, Wave speed. Fields that expect a unit say so next to the label.
Where does Period come from?
It comes from T = 1 / f — the primary relation: the period is the reciprocal of the frequency. A higher frequency always gives a shorter period, in seconds.
What is the most common mistake with the Period Of A Wave Calculator?
Multiplying instead of taking the reciprocal. Using T = f rather than T = 1/f reverses the relationship completely. A high frequency must give a short period, so if your answer grows when the frequency grows, the operation is wrong. Checking the units also helps: a period has to come out in seconds.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate The Period Of A Wave page.
