CCalclabhub

Geometry

Area of the sector

The sector occupies the same angular fraction of the full circle's area as the arc does of its circumference. Equivalently, A equals half the radius times the arc length.

Last updated

The Formula

A = πr² × (θ / 360)

The sector occupies the same angular fraction of the full circle's area as the arc does of its circumference. Equivalently, A equals half the radius times the arc length.

SymbolMeaning
rRadius of the circle
θCentral angle
ASector area

What Each Symbol Means

rlength

Radius of the circle

The same radius used for the arc length.

θdegrees

Central angle

Swept angle in degrees, identical to the one used for the arc.

Aarea

Sector area

Area of the wedge bounded by the two radii and the arc.

See It Worked With Real Numbers

A formula on its own does not tell you which number goes where. The how to calculate the arc length of a circle page applies this equation to a concrete case, shows every intermediate step, and names the mistakes that produce a wrong answer even when the algebra is right.

Where This Formula Appears

This equation is the working core of How To Calculate The Arc Length Of A Circle, filed under Math. Every number the guide produces comes from substituting into this one line.

Common Questions

What is the formula for Area of the sector?

The formula for Area of the sector is A = πr² × (θ / 360). The sector occupies the same angular fraction of the full circle's area as the arc does of its circumference. Equivalently, A equals half the radius times the arc length.

What does each symbol in Area of the sector stand for?

r is radius of the circle; θ is central angle; A is sector area.

What units should I use with Area of the sector?

Substitute r in length, θ in degrees, A in area. Convert every input to those units before you start, because the equation only returns the right answer when the units on both sides agree.

What is a common mistake when using Area of the sector?

Confusing the radius with the diameter. The circumference formula uses the radius, so a diameter must be halved first. Substituting a diameter of 20 as if it were a radius of 20 doubles the circumference and therefore doubles the arc length. Check which measurement the problem actually supplies.